Hi I'm on the UEB NFR edition and recently cleared backups/hosts from within the Dashboard to start again. I setup my 2 Physical hosts / single processors each and managed a test backup of a VM. When I've tried to restore I am told that I exceed the sockets and cannot complete it.
I have then also tried to create a scheduled calendar backup of a VM to be told the same thing.
Support are being a little slow on this - thinking its a simple issue with the database still holding the "old" hosts. However my support case has been open over a week and a half, I get an initial contact from a couple of the engineers but then they go silent on me....
Is there somewhere I can check myself to remove the old Hosts ?? Thanks
Dave